Business Community > All Threads > How to combine VLANs from two SDNs?
< All Threads

How to combine VLANs from two SDNs?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

How to combine VLANs from two SDNs?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to combine VLANs from two SDNs?
How to combine VLANs from two SDNs?
2023-12-14 19:58:45 - last edited 2023-12-25 09:55:35
Tags: #VLAN & Multi-Networks
Model: OC200   ER605 (TL-R605)   SG2210P  
Hardware Version: V1
Firmware Version: V5 12 9

 

If you start with two independent SDNs with ER605/OC200/TL-SG22110P each with their own ISP.

  • SDN#1 has a VLAN 31 (192.168.31.1/24)
  • SDN#2 has a VLAN 32 (192.168.32.1/24)
  • On SDN#1 if the managed switch provided VLAN 31 (untagged) to Server 1A and Camera 1B then they should be able to communicate with each other (e.g., the Server record the Camera). Devices 1A and 1B could access the internet via Router ER605#1.
  • Likewise SDN #2 if the managed switch provided VLAN 32 (untagged) to Camera 2A and 2B then they should be able to communicate with each other as well. Devices 2A and 2B could access the internet via Router ER605#2.

 

  • QUESTION: If the two SDN were nearby, how could VLAN 31 and VLAN 32 be interconnected to allow Server 1A to record Cameras 2A and 2B?
  • Could a simple switch (TL-SG108) be added combining the untagged networks VLAN 31 and VLAN32 without causing problems in either SDN thus allowing Server 1A see Cameras 2A and 2B? What might the complications be?
    • Could the subnet mask for the Devices be made wider without causing problems? (e.g., router problems)
    • Seems like the DHCP ranges for each router on their VLAN should be easily set up to not cause problems?

 

clip image002

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:How to combine VLANs from two SDNs?-Solution
2023-12-15 15:13:18 - last edited 2023-12-25 09:55:35

  @BobBlur 

 

You should be ok to x-connect the user VLANs this way, you just need to ensure that you don't reuse IPs on both sides, but that each site router is aware of the VLANs being shared so it can help with inter-VLAN routing but DON'T enable DHCP on both sides for any given VLAN!

 

The ONE thing to avoid though is merging the management VLANs/broadcast domains, you don't want the controllers interfering with each other (in theory they shouldn't, but I would explicitly exclude your management subnet and VLAN from the 2210 port profiles that x-connect via the 108.

<< Paying it forward, one juicy problem at a time... >>
Recommended Solution
  0  
  0  
#3
Options
11 Reply
Re:How to combine VLANs from two SDNs?
2023-12-14 20:06:34 - last edited 2023-12-15 01:33:33

  @BobBlur 

797acaa597014bddbd9d6c9e689d587c

  0  
  0  
#2
Options
Re:How to combine VLANs from two SDNs?-Solution
2023-12-15 15:13:18 - last edited 2023-12-25 09:55:35

  @BobBlur 

 

You should be ok to x-connect the user VLANs this way, you just need to ensure that you don't reuse IPs on both sides, but that each site router is aware of the VLANs being shared so it can help with inter-VLAN routing but DON'T enable DHCP on both sides for any given VLAN!

 

The ONE thing to avoid though is merging the management VLANs/broadcast domains, you don't want the controllers interfering with each other (in theory they shouldn't, but I would explicitly exclude your management subnet and VLAN from the 2210 port profiles that x-connect via the 108.

<< Paying it forward, one juicy problem at a time... >>
Recommended Solution
  0  
  0  
#3
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 15:18:07

  @BobBlur 

 

Also, since I don't have the luxury of a 60km ethernet cable, so I just set up a L2TP/IPsec VPN from Site2 and used the 'network extension' mode to allow certain subnets on either side to see each other.  I even used a policy route to force one of the remote VLANs across this VPN tunnel to use the local ISP1 instead of ISP2.  This has been working well for me, though I do have to set a monthly reboot schedule for my ER605v1's so they don't lockup due to memory starvation.  My cameras are happily recording away at Site1 from Site2.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#4
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 17:29:46

  @d0ugmac1 

 

Thanks so much for your help.

 

Your solution is a good onel, but my ISPs have very low bandwith. I can afford a single mode fiber cable between the "LAN side" of the SDN running at a Gb. (-:

 

Thanks again.

  0  
  0  
#5
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 18:10:01 - last edited 2023-12-15 18:12:04

  @BobBlur 

 

I'm still noodling the ramifications of this ie L2 Broadcasts vs L3 routing, but something like this should be a good start.

 

By default TPlink routers enable inter-VLAN routing, so you will need to add ACLs in the 2210's to block comms from 31/32 VLANs to the 10's and 20's

 

Also, (deleted by mistake) the x-connected 2210 ports should belong to both 31 AND 32.

 

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#6
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 20:33:35

  @d0ugmac1 

I could not get my head around your reply. I generalized what I thought you were trying to do as shown below

 

I have another idea in the next post.

  0  
  0  
#7
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 20:38:54

@d0ugmac1 

 

Another idea would be shown below. Putting two Eithernet adapters on the server or doing a simular thing with some router magic,

 

  0  
  0  
#8
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 20:49:55 - last edited 2023-12-15 20:50:21

  @BobBlur 

 

Well you could really simplify things with the second NIC...just plug the other site into it and be done!

 

 

 

 

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#9
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 21:02:42

  @d0ugmac1 

Apparently my last graphic would not copy to the message. I think I got what you were organially saying.

 

  0  
  0  
#13
Options
Re:How to combine VLANs from two SDNs?
2023-12-15 21:09:58
I think I have most of the hardware, so I think I will prototype it on the test bench and see if I can get it to work. (-: Thanks so much for your help.
  0  
  0  
#14
Options
12

Information

Helpful: 0

Views: 1016

Replies: 11

Tags

VLAN & Multi-Networks
Related Articles
How to combine two DSL connections in one
1329 0
connect two VLANs on managed switch
302 0
Vlans with two switches
867 0
Crossover Vlans
170 0
Vlans and Profiles
448 0
Two ISP in different VLANs
783 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.