ArcherC8LV5Online
Following: 0Followers: 9
Forums/ Wi-Fi Routers
2024-08-20 23:28:52
Re:LAN stuck on 100mbps after setting up EasyMesh
@bigshooTer39 Cables will cause it to drop to 100 as that speed uses only half of the wires where all are needed for faster speeds. I would test them again and check the ports on the router for bent...
0HELPFULS
Forums/ Wi-Fi Routers
2024-08-19 17:06:42
Re:Can I have two different routers working multiple WiFi signals on my home network.
@Kidkong If you want to use two routers, you set up the main router in router mode and the other in AP mode. The AP mode router is the one you would turn off or on to control the network.
0HELPFULS
Forums/ Wi-Fi Routers
2024-08-19 16:56:17
Re:Configure tp-link Wi-Fi 6 router and three tp-link Wi-Fi 6 access points with the same SSID/password
@Gor-Mahia1 I would think you need to set up a mesh network. If all the routers are are onemesh, you should be able to do it.
0HELPFULS
Forums/ Wi-Fi Routers
2024-08-17 19:57:46
Re:Extend Wi-fi
@Maxaduke the main thing with an extender is you need to place it where there it gets a good strong signal from the router. Place it closer to the router, sort of half way or less. Also try moving...
0HELPFULS
Forums/ Wi-Fi Routers
2024-08-11 10:03:12
Re:Cox Panoramic Modem and TP-Link WiFi - performance degradation over time
@FalkumelvaBob few things... Your Cox modem should be in 'Bridge mode' so it acts just as a modem and not also as a router. VPN can slow down networks depending on the one used and how it is...
0HELPFULS
Forums/ Wi-Fi Routers
2024-08-07 12:05:44
Re:ethernet wont connect
@ZachAttack I would try a factory reset and see if the problem still exists. If the WIFI works and the Ethernet does not and multiple devices using known good cables does not work on the Ethernet...
0HELPFULS
1181920...