Can't connect to reconfigure TL-WR702N
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can't connect to reconfigure TL-WR702N
Model :
Hardware Version :
Firmware Version :
ISP :
I have a TL-WR702N that I have successfully used as an access point in the past. I haven't used it for a couple of years, but I'd like to reconfigure it to Client mode to use to give a wired device wireless access. However, when I try to connect to IP address 192.168.0.254 in my web browser via ethernet cable, it can't connect. I have reset the unit and waited until it stops flashing, However, as soon as I plug the ethernet cable in it starts flashing again and I can't connect.
Any suggestions would be welcome. Thanks.
Hardware Version :
Firmware Version :
ISP :
I have a TL-WR702N that I have successfully used as an access point in the past. I haven't used it for a couple of years, but I'd like to reconfigure it to Client mode to use to give a wired device wireless access. However, when I try to connect to IP address 192.168.0.254 in my web browser via ethernet cable, it can't connect. I have reset the unit and waited until it stops flashing, However, as soon as I plug the ethernet cable in it starts flashing again and I can't connect.
Any suggestions would be welcome. Thanks.