My understanding is that the Smart DHCP is intended to kick in if the powerline device detects that there is no DHCP server on the network. I guess this was done to allow clients to access the config...

It's very disappointing that the TP-Link folk responding to a message to this thread, over 200 messages long, don't consider that context and treat new messages as if they were brand new support...

I was subsequently informed by TP-Link support that the ER605 also uses 192.168.0.1 as a default address. It appears that I was reaching this instead of the switch address due to the conflict and...

@Virgo it was already gone. I noticed that after resetting, the switch picked up a different address by DHCP which was not showing the error message and I was able to add it. However it was also...

My switch lost connection to the Omada Controller, so I used the reset button to factory reset it. Now when I access it via the factory default IP (https://192.168.0.1) the page says that the switch...

I'm getting this as well. I see that current logs is 9k+ and the maximum is 10k+ (whatever the + means). I would happily clear out my logs after checking them so as not to get this message so...