@JohnWesleyS so you are looking for the controllers local IP address? Launch, go to settings, system settings and it is under Access Config. (Bottom of image)

@RonaldS Something like this but can't really lay it out completely not knowing how you plan on powering each device. The CPE210 at Starlink end will be set to Access Point mode and the CPE210 on...

@ASGADFGWT until someone else answers, confirm latest firmware on all devices. I'm sure you have probably already done this. When you say one EAP gets stuck in a loop, is it always the same EAP? If...

@smatom Take the EAP on the 200' run and swap it out with one of the other EAPs. See if the problem follows the EAP or remains with the cable. The length of the cable should not be an issue.

@jmursyd Based off your statement, it sounds like you are trying to connect wireless clients to the CPE710 at your home. That would not be ideal. The CPE710 configuration should be looked at like one...

@ShipShop probably not what you want to hear, but spend the $89 on the OC200 HW Controller. Even if its just to test and verify that the software controller is the issue.