@PP_link Sometimes you may not get the help you need by asking questions on Internet. If I were you, I would spend more time studying the switch’s manual. What you were trying to do looks like a...

@SoulRaven An EAP configured according to the screenshot you have provided earlier will do the following: Frames received from devices connected to “TP-Link_2.4…” will be sent untagged to the switch....

@SoulRaven You should have no issue with VLAN 14. As far as the VLANs 1 and 100 are concerned, it all depends which one is native on the CISCO switch since the native VLAN means untagged traffic on...

@SoulRaven The trunk configuration looks fine, but I’m not sure how you have configured the AP. What’s the IP address of the AP? Is it from the subnet of VLAN 1 or VLAN 100? If your native VLAN is...

@CETBOR That’s a strange arrangement, but it should work in the theory. However, you may experience performance issues since the traffic from Internet would be going first through Switch A, LAG,...

@Charl99 “How can I "transfer" the port forward via the switch?” In general, you cannot set up port forwarding on a switch. A typical switch just does not provide this function. That’s O.K. I don’t...