View Camera on PC/NVR/NAS
The Tapo cameras, which support the RTSP and ONVIF (Profile S) protocols, allow it to be viewed not only through the Tapo app but also through third-party programs on PC/NAS/NVR. This greatly enriches the usage scenarios of the camera. You are welcome to share your experience and preferred usage scenarios when viewing a camera on a PC/NAS/NVR.
View Camera on PC/NVR/NAS
Note: currently, some battery-powered cameras, such as Tapo C420, C400, and D230, do not support being viewed via the RTSP/ONVIF stream. 1. If the camera has subscribed to the Tapo Care service and in
ONVIF/RTSPHighlighted ThreadOfficial
0Helpful
30937Views
Knowledge BaseView Tapo cameras on PC/NVR/NAS
Introduction What are ONVIF (Open Network Video Interface Forum) and RTSP (Real-Time Streaming Protocol)? ONVIF is an open standard organization that promotes interoperability among network video devi
ONVIF/RTSPHighlighted ThreadOfficial
0Helpful
2783Views
While I can view my Tapo C200 through the mobile app, I would also like to use a PC to view it. Is there some way I can view it using my PC?
ONVIF/RTSP
By
Ojos
· Latest post Yesterday
by PotatoSalad
315Helpful
622434Views
I have problem with my camera tapo c200 after update the latest firmware version 1.4.1 after update, my camera always disconect from my NVR (Uniarch), before update my camera and nvr working normaly f
FirmwareONVIF/RTSPLive ViewDevice Connectivityv1.4
By
Nurdi-99_ID
· Latest post 11 hours ago
by Solla-topee
0Helpful
106Views
Hello.... I have a problem, after a firmware update from my c200 camera i get a strange view in the PC app i use (ip camera viewer) All other camera';s don't have this problem only the one has that up
FirmwareONVIF/RTSPLive View
0Helpful
54Views
Hi! This is a feature request for battery powered cameras to have a continuous recording/always on feature. Understandably this would drain power quickly, but customers can opt for a solar panel, to r
Motion DetectionONVIF/RTSPNotificationContinuous Recording
By
tapouser-927593
· Latest post Yesterday
by Wayne_ER602_V2
9Helpful
1113Views
Hey, I would like to see the camera image on my smart TV (Android). ONVIF/RTSP, not supported, okay, but then how can I watch it? If I can't watch it on TV: I've already installed it, but I want my mo
ONVIF/RTSP
By
sdaniel1335
· Latest post Yesterday
by Summer_S
0Helpful
52Views
Is it possible to unlock rtsp for users. I see that the camera has rtsp only locked. Yes immediately someone will say that rtsp for continuous viewing will use battery but who will use it count. Rtsp
ONVIF/RTSPFeature Request
By
Darek1988
· Latest post Yesterday
by tapouser2025
1Helpful
553Views
Hello I have had this unit integrated into a Frigate for a few months now, I use the low resolution Stream 1 for detection and the Stream 2 for recording, I recently acquired another one to complete t
FirmwareONVIF/RTSPFRIGATE
By
HarryTuttle
· Latest post Monday
0Helpful
33Views
使用第三方 NVR 時，我注意到 TAPO C225 的STREAM2設置為更高的解析度/品質，這會導致設備無法及時預覽流。相比之下，使用相同的 NVR，C200 和 C210 型號工作正常。 是否可以通過固件升級來修改 STREAM1/STREAM2 設置？此外，對於 C200、C210、C220 和 C225 型號，STREAM1 和 STREAM2 配置是什麼？ 總結一下： C200 和 C
FirmwareONVIF/RTSP
By
FATECOOKIES
· Latest post Monday
by Solla-topee
1Helpful
48Views