IP CAM NC200 // setup via tpcamera ok, wfi set-up ok, then dead ... .
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IP CAM NC200 // setup via tpcamera ok, wfi set-up ok, then dead ... .
Model :
Hardware Version :
Firmware Version :
ISP :
Hi we have IP CAM NC200 latest FW
Set-up via tpcamera + test via local all works fine
Then in the last step it says: unplug cable to change to wifi
So we do so: then I see in settings WIFI Connection Status: connected
But cloud can not access the camera, ios app cannot connect
So in essence nothing works until I plug in the cable again
Is there some kind of Port Forward I have to enable? Something else?
Is there a difference between WIFI and UTP cable network?
Help appreciated
This is ERR log
Hardware Version :
Firmware Version :
ISP :
Hi we have IP CAM NC200 latest FW
Set-up via tpcamera + test via local all works fine
Then in the last step it says: unplug cable to change to wifi
So we do so: then I see in settings WIFI Connection Status: connected
But cloud can not access the camera, ios app cannot connect
So in essence nothing works until I plug in the cable again
Is there some kind of Port Forward I have to enable? Something else?
Is there a difference between WIFI and UTP cable network?
Help appreciated
This is ERR log
| [2017-04-19/09:08:50] |
Cloud |
ERROR |
Failed to send relayReady to cloud, result:-50010 |
| [2017-04-19/09:03:42] |
Cloud |
ERROR |
Failed to send relayReady to cloud, result:-50010 |
| [2017-04-19/08:56:56] |
Cloud |
ERROR |
NAT type:-1, errMsg:Success |