Hi,

Over the last few days the status lights on my H200 hub starts flashing red and green slowly.

According to the manual this means it's "ready for setup", but it is set up and operating normally.

If I reboot it, the status light turns to solid green, as expected, but then, a day or so later it starts doing it again

As far as I can tell, nothing unusual or unexpected is happening on my network or with any of my Tapo devices.

All of my devices have the latest firmware.

I have a doorbell, a  H100 and a C120 camera (although that obviously doesn't connect to the hub)

Any suggestions what might be going on?