Smart Home Community > Tapo Smart Camera > NC450 - slow response speed
< Tapo Smart Camera

NC450 - slow response speed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NC450 - slow response speed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC450 - slow response speed
NC450 - slow response speed
2017-07-28 19:30:25
Model :

Hardware Version :

Firmware Version :

ISP :

I have NC450 on ethernet - but it is very slow to respond. It puts up a message [ Pan-tile starting] Should this be Pan-Tilt??
The connection speed showing on my app varies but is never above 50kbs. What should it be? My broadband connection is only about 8MB in this location.
  0      
 
  0      
 
#1
Options
3 Reply
Re:NC450 - slow response speed
2017-07-31 16:18:34
Are you at home when trying to access it? It should be faster in the local network, while for remote access, it would be slower depending on your internet speed.
  0  
  0  
#2
Options
Re:NC450 - slow response speed
2017-08-01 16:23:42
It's a remote connection over the internet. But the performance is very disappointing. There's enough. Sndwidth at both ends. Can anyone else advise what speed they show from their cams in this set-up?
  0  
  0  
#3
Options
Re:NC450 - slow response speed
2017-08-16 15:12:36
My cams sometimes only show 5kbps, but I can watch the video normally.
If you watch the camera on tplinkclound.com over the internet, is it also very slow?
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 640

Replies: 3

Related Articles
Tracking response is slow
266 0
NC450 Not powering up
655 0
NC450 not connect
5380 0
nc450
462 0
nc450 tls configuration
2113 3
NC450 1.5.5 firmware
1097 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.