updating and installing
my c310 is taking ages to update and install...even after a reset, my wifi signal is strong infact i have my camera almost next to my phone and router, any advice please ? my only option at the moment is to use the camera without any updates as it works fine if i dont update the firmware.
thanks
Mark
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
If you have a problem updating the firmware of the Tapo camera, please refer to the instructions below to troubleshoot.
What to do if the firmware update of my Tapo smart devices fails?
If the problem remains, please confirm the following information.
1. What's the hardware and firmware version of your camera?
2. What error message appears when you update the firmware?
Best Regards
- Copy Link
- Report Inappropriate Content
@Solla-topee hi thanks i have already done this, its 1.3.7 and i get no error messages its just constantly trying to install the new firmware but never does it
- Copy Link
- Report Inappropriate Content
Hi,
You can try to enable a hotspot Wi-Fi on your phone, factory reset the camera, configure it with another phone, connect it to the hotspot Wi-Fi, and then check if you can update the firmware successfully.
If so, after you update the firmware, you can reset the camera and configure it again to connect to your home Wi-Fi network.
Best Regards
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 112
Replies: 4
Voters 0
No one has voted for it yet.