Re-fit base on TC70?
Unfortunately I accidentally knocked my TC70 camera and the base became detached from the main unit. I am struggling to fit it back correctly, can anyone offer a suggestion as to the best way to pop it back together?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Summer_S at the umteenth attempt, I finally managed to clip the base part of the camera onto the upper housing and it was no longer jammed stuck in one position. It was more "luck than management" that it clipped together.
Given how easily the base falls off the upper part, it is surprising nobody else seems to have experienced the falling apart of the housing. A slight knock and the base falls off!
Thanks anyway.
- Copy Link
- Report Inappropriate Content
Hi，
We have the mount instructions in the following video, you can check if it helps.
How to Mount Your Tapo Pan&Tilt Wi-Fi Camera to a Wall: Tapo C200/Tapo C210/ TC70?
Best Regards
- Copy Link
- Report Inappropriate Content
@Solla-topee Unfortunately that is not the problem I have, the rotating part of the camera base became detached and I cannot work out how to clip it back on again. It is not the part that screws to the wall, it is the lower rotating part of the camera housing.
Thanks
- Copy Link
- Report Inappropriate Content
@Woody71 a picture of the camera and base would help give you an idea of your situation.
- Copy Link
- Report Inappropriate Content
@Summer_S at the umteenth attempt, I finally managed to clip the base part of the camera onto the upper housing and it was no longer jammed stuck in one position. It was more "luck than management" that it clipped together.
Given how easily the base falls off the upper part, it is surprising nobody else seems to have experienced the falling apart of the housing. A slight knock and the base falls off!
Thanks anyway.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 315
Replies: 5
Voters 0
No one has voted for it yet.