@Great_Ripcord Yes, this is the same problem for me. Delay parameter in shortcut is ignored, if the shortcut is use in automation.

  @Wayne-TP Hi, yes, all automations are linked to my email address
The following do not work:

"test" (delay10 sec. is ignored)

"TL1 - dvojklik - zapnout full alarm" (delay 30 sec. is ignored)

"TL1 - klik - zapnout soft alarm" (delay 3 sec. is ignored)

  @Wayne-TP 

thanks, replied 

  @Wayne-TP 

a change in behaviour tonight. It will now run the automation but ignores all the delays inside of all of the shortcuts. I haven't changed anything but I have been in to each shortcut, edited something, saved it, then changed it back and resaved it

now it runs

Bulb on 

the all the -5% brightness steps (that should be 2mins apar)

then bulb at 1%
then bulb off

all within 5-6 seconds!

it's not fixed but it's new behaviour 🤣

  @Wayne-TP  Today the delayed automation shortcuts started working again. Thanks.

But there is a new problem.

Delayed automation cannot be turned off with a shortcut. When a delayed automation is activated and then I deactivate it with a shortcut, the action still starts after the delay. If I disable the automation manually directly, it's ok (the countdown stops and the actions in automation doesn't start)

Two test automations are created in my account: "test1-countdown-start" and "test2-countdown-interupt". Activating "test2" cannot interrupt the "test1" automation countdown. The automation is deactivated, but the countdown does not stop. Everything was working fine until the problems with the shortcuts started.