Tapo P105 schedule timer issues
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I recently bought a Tapo product Mini Smart Wifi Plug model P105.
My question is why I can't configure the Schedule, Timer and Away mode on my device. It always shows the Operation failed, please try again later.
Everything is ok, just the Schedule, Timer and Away Mode are not working.
Is this a defective item or just a software issue?
Model: TapoP105
Serial Number : 2232048000852
Thanks and Regards,
Rasell
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
May i know what router are you using? Please try to change router DNS to 8.8.8.8 and 8.8.4.4, test if that helps.
- Copy Link
- Report Inappropriate Content
I manually changed the dhcp settings on my router to set the stated primary and secondary DNS servers. I monitored it for days now. After their IP parameters were updated, the devices settings were updated too and it worked fine. , but after the next power loss, the issue still persists.
- Copy Link
- Report Inappropriate Content
I'm experiencing the same.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Wayne-TP i have the same issue. did you find the solution?
- Copy Link
- Report Inappropriate Content
it seems to be fixed after I remove the plug from the app and connect again.
- Copy Link
- Report Inappropriate Content
I have the same issue. Whenever there is a power glitch or even a short power outage, the programmed schedules will not work. Only the on/off function will work.
You have to remove the device and reset it in the app. Pain in the a**
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
This Solution Applies To
Tapo P100(US) 1.0
Tapo P105(US) 1.0
Description
We recently discovered that Tapo P100/P105 users from the Philippines are more likely to experience issues with time-related functions such as schedules or timers after a power outage or network fluctuation. Initial analysis revealed that the problem was caused by an anomaly in the time calibration of the device under the local ISP network.
Solution
Fixed on the latest firmware
- Tapo P100(US) 1.0, Firmware 1.4.4 Build 20240514 Rel.35017
- Tapo P105(US) 1.0, Firmware 1.4.5 Build 20240514 Rel.36508
If your device is not the mentioned model but experiences a similar issue, refer to the suggestion here: What If Schedule Doesn't Take Effect - Unable to Create/Edit Schedule/Timer/Away Mode for Tapo Plug
- Copy Link
- Report Inappropriate Content
@Wayne-TP it appears that the problem was solved after the SW upadate. thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 3413
Replies: 23
Voters 0
No one has voted for it yet.