Kasa Power Bar

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Kasa Power Bar

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Kasa Power Bar
Kasa Power Bar
2022-07-12 13:22:45
Model: Kasa  
Hardware Version:
Firmware Version:

Hi all, 

 

Just got the Kasa power bar and installed the app on my phone. I did a test schedule run to turn on a plug for 4 mins and turn it back off. When I went to the run time tab in the app I was expecting to see 4 mins runtime today however its showing as 6 minutes. Has anyone had this issue? 

 

Also is there a way to get notified that the schedule has started and stopped?

  0      
  0      
#1
Options
1 Reply
Re:Kasa Power Bar
2022-07-13 01:34:00

  @TUMAS 

May I know the model of your Kasa smart device? You could try some basic troubleshooting if the runtime is not correct.

Please confirm the Kasa app to date and kasa device firmware are both up-to- date
Try a factory reset on smart device and resintall it in the APP :
How to reset TP-Link Kasa smart switch and plug

There isn't  notification for schedule or timer in kasa app yet, while there is a way to see if the schedule has started. Before the schedule rule take effects there is an event below the smart device on Kasa APP mainpage, if that event has gone and goes to next event, that means it has take affected. 

  0  
  0  
#2
Options