@TP-Link yes, the default mode of the P100 is always "off" once recovering from a power outage and I would like this to be "on" instead. 

TP-Link wrote

@RustyGolfClub 

Good day,

Sorry for the delay.

Are you trying to say that the default mode of the P100 is always off once recovering from the power outage?

--if yes, we have reported to this feedback to the senior engineers already for further evaluation.

 Or the device connected to the plug stays off even the plug is turned on?

Thank you very much.

TP-Link wrote

@RustyGolfClub 

Good day,

Sorry for the delay.

Are you trying to say that the default mode of the P100 is always off once recovering from the power outage?

--if yes, we have reported to this feedback to the senior engineers already for further evaluation.

 Or the device connected to the plug stays off even the plug is turned on?

Thank you very much.

Thanks for getting back to me - I have needed to build an automation routine that turns all the plugs on every 60 minutes because of this and that makes no sense at all

@TP-Link Hello, I just unpacked my tapo P100 and also updated the firmware. Everything done...today. My Question is... Is this issue already been solved? I also want it set default to ON especially from brown out situation. Mine is set default to OFF everytime the power is back.

Yes you must fix this because it's very important otherwise if it can't be done you have to create push notifications or email notifications to the user so he will see the power outage/recover and switch on the plug.