Tapo P100 default status ON
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
When power goes down, the default state of the P100 is OFF. I'd like to set the p100 in a way when if a power cut, the default state is ON when power comes back. Is this possible?
Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello@JuSu, this feature is planned on Tapo P100 V1, but I'm not sure about the estimated date either.
It is recommended to wait for further firmware update on Tapo APP, I will also update on below thread for the progress of this feature:
[Tapo Plug Feature request] Set Default State after Power Failure is Now Available (Tapo P100 V1.2 / P110)
- Copy Link
- Report Inappropriate Content
Hola @Solla-topee
El Tapo P110 ya tiene esta funcion de fabrica? o a partir de que version de Hardware o firmware lo tiene?
- Copy Link
- Report Inappropriate Content
Hello@Franrz Tapo P110 has this feature all the time since factory firmware.
- Copy Link
- Report Inappropriate Content
Ok, Thank you.
Solla-topee wrote
Hello@Franrz Tapo P110 has this feature all the time since factory firmware.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 6
Views: 7637
Replies: 34
Voters 5
