NC450 gets other centrepoint after reboot
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC450 gets other centrepoint after reboot
Hello,
My NC450 V2 camera worked vey well for a long time but recently the camera doesn't go back to the same point after rebooting. the focus is differrent evey time. Sometimes it's higher en sometime lower so that i see the ceiling or the floor. The current firmware version is 1.5.0 built 2018.10.22.
Can someone help me?
Re:NC450 gets other centrepoint after reboot
On the tpCamera app, when you go to the live view page, you can try to adjust the position of the camera focus by your own.
Here is the picture.
Nice to Meet You in Our TP-Link Community.
Check Out the Latest Posts:
Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN
Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router
EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller.
Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More
If you found a post or response helpful, please click Helpful (arrow pointing upward icon).
If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.