I recently purchased the KE100 kit with 6x radiator valves and the smart hub, which I have setup through my house. I have a few practical issues I'm struggling with that I think some user experience would help with.

All of the devices are installed without need for adapters (I have the standard M30 x 1.5 valves), they are all connected to the hub, firmware is up-to-date and I have run the calibration on them all.

I am using a hive thermostat to control the boiler.

1. How do I ensure that the hive thermostat is running when the various radiators around the house need heat? I didn't install a KE100 on the hall radiator where the thermostat is. However logic says that if the hall is up to temperature then the system will shut off regardless of the status of the other radiators in the house.

2. Some of the valves seem to never shut off, regardless of the room temperature (see picture). Is this common and how might I combat this?

3. Although the above image shows some rooms over 30°C, they actually aren't. It seems the valves are massively mid-reporting the room temperature as the pipe itself is getting extremely hot. I know I can buy external tado thermometers, but another 5 of those seems like a lot of extra expense. Especially since the valves do not seem to be turning off properly anyway.

Any advice on setup would be greatly appreciated.

Thanks in advance.