Home

Forums

Stories

Knowledge Base

TP-Link Community > Tapo Smart Plug > P110 Setup

< Tapo Smart Plug

P110 Setup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

P110 Setup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

P110 Setup

PeterM44

2023-02-04 18:05:18 - last edited 2 weeks ago

Posts: 1

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2023-02-04

P110 Setup

2023-02-04 18:05:18 - last edited 2 weeks ago

I have installed several Tapo P110 plugs to monitor electricity usage of devices in my home.

All has worked well, apart from when setting up one of my Tapo P110 setup, I get to "Connect To Your Tapo Device", but the Tapo P110 is not broadcasting a "Tapo_Plug_XXXX" wi-fi address. Before discarding the plug as broken, I wondered whether there were any suggestions, or any TP-Link diagnostic software that would help me get the unit working again?

1 Accepted Solution

Wayne-TP

2023-02-06 09:08:51 - last edited 2 weeks ago

Posts: 3912

Helpful: 717

Solutions: 1088

Stories: 12

Registered: 2020-06-23

Re:P110 Setup-Solution

2023-02-06 09:08:51 - last edited 2 weeks ago

@PeterM44

Thank you for the feedback. Please factory reset the Tapo plug if its default wifi is not broadcasting. Make sure it is in pairing mode (led blinking orange and green) before checking the wifi signal.

How to reset Tapo P110: press and hold the reset button for 10s until the led blinks green (then blinking orange and green)

Use other mobile devices to check if the plug wifi really disappears. If the plug wifi cannot be found on all mobile device's wifi list when it is in pairing mode, the device might be defective, please contact retailer or local TP-Link support to check warranty.

▶ Landscape Mode - Tapo App for Pad ▶ Share Your Pet Story. Win Free Tapo Care! ▶ Smart Action 2.0 Explore and meet the next level home automation.

Recommended Solution

1 Reply

Wayne-TP

2023-02-06 09:08:51 - last edited 2 weeks ago

Posts: 3912

Helpful: 717

Solutions: 1088

Stories: 12

Registered: 2020-06-23

Re:P110 Setup-Solution

2023-02-06 09:08:51 - last edited 2 weeks ago

@PeterM44

How to reset Tapo P110: press and hold the reset button for 10s until the led blinks green (then blinking orange and green)

▶ Landscape Mode - Tapo App for Pad ▶ Share Your Pet Story. Win Free Tapo Care! ▶ Smart Action 2.0 Explore and meet the next level home automation.

P110 Setup

P110 Setup

Information

Voters 1

Tags