Site to Site -> 2 x TL-R600VPN v4.0
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dear All,
We have follow this guide: https://www.tp-link.com/br/support/faq/2163/
But no connection stabilished between the 2 sites.
On logs, we got only this from one side:
WAN1: IKE negotiation began in initiator mode. (Mode=Aggressive Mode, Peers=179.181.77.201<->189.6.235.255)
Who can help configuring this IPSec Tunel?
Thanks,
Rafael
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @RafaelRibeiro,
Please upgrade the firmware first, the latest firmware version is Build 20200313.
https://www.tp-link.com/br/support/download/tl-r600vpn/#Firmware
But no connection stabilished between the 2 sites.
If the TL-R600VPN router is behind a NAT device, we need to configure virtual servers on the NAT Device, open ports UDP 500 and UDP 4500 for the VPN router. This step is mentioned at the part >>2.2.3(Optional) Implementing configuration for NAT Devices<< from the CG below.
If both TL-R600VPN routers are directly connected to the Internet with public IP addresses, please double-check the IPSec VPN settings on both routers, make sure all the parameters including Remote Gateway/Subnet, Local Gateway/Subnet, Pre-shared Key, the proposal and Local/Remote ID Type match at both sides.
- Copy Link
- Report Inappropriate Content
Dear @RafaelRibeiro,
Please upgrade the firmware first, the latest firmware version is Build 20200313.
https://www.tp-link.com/br/support/download/tl-r600vpn/#Firmware
But no connection stabilished between the 2 sites.
If the TL-R600VPN router is behind a NAT device, we need to configure virtual servers on the NAT Device, open ports UDP 500 and UDP 4500 for the VPN router. This step is mentioned at the part >>2.2.3(Optional) Implementing configuration for NAT Devices<< from the CG below.
If both TL-R600VPN routers are directly connected to the Internet with public IP addresses, please double-check the IPSec VPN settings on both routers, make sure all the parameters including Remote Gateway/Subnet, Local Gateway/Subnet, Pre-shared Key, the proposal and Local/Remote ID Type match at both sides.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1135
Replies: 2
Voters 0
No one has voted for it yet.