R600VPN Site to Site ASA5510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

R600VPN Site to Site ASA5510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
R600VPN Site to Site ASA5510
R600VPN Site to Site ASA5510
2015-06-23 23:19:11 - last edited 2021-08-21 05:08:41
Region : UnitedStates

Model : TL-R600VPN

Hardware Version : V2

Firmware Version :

ISP :


I have two remote offices. Both now have the R600VPN router. I use a Cisco ASA5510 in the office. I have Site to Site VPN setup for each in the ASA. I have IPsec set on each of the routers. Everything works fine except I would like them to have access to the internet even if the VPN is not working. Or, even if the VPN is turned off I should still be able to access their router.

For example, I turned the IPsec off in the router for one location. They no longer have internet which they should, the router is still plugged into the modem and the modem still has connectivity. I also can no longer get to their router or any of the equipment on their site. The previous routers were able to connect even without the VPN. What is the difference now?
  0      
  0      
#1
Options
4 Reply
Re:R600VPN Site to Site ASA5510
2015-06-24 20:32:33 - last edited 2021-08-21 05:08:41
Post screen shots of your configurations for the R600VPN. Also include your network diagram.
  0  
  0  
#2
Options
Configuration
2015-07-28 13:19:56 - last edited 2021-08-21 05:08:41
Home office has westell modem bridged with ER604W PPPoE. Drobo connected port 4 PC connected Port 3. Office has 2wire bridged modem R600VPN PPPoE. 4 computer connected.

I used this exact setup with exception of the pre-shared key, DH5, 192.168.1.0/24 (sharonofficeoffice.no-ip.org) (R600VPN), and 192.168.10.0/24 (sharonofficehome.no-ip.org) (ER604W)

http://www.tp-link.com/en/faq-380.html. It connects perfectly but I cannot view the Drobo (NAS) from the ER604W


VPN Setup.pdf


If you need image of any other screen let me know and I will post them.
  0  
  0  
#3
Options
Re:R600VPN Site to Site ASA5510
2015-08-11 11:40:11 - last edited 2021-08-21 05:08:41
You will need to configure internal DNS or WINS.
  0  
  0  
#4
Options
Re:R600VPN Site to Site ASA5510
2015-08-13 21:26:07 - last edited 2021-08-21 05:08:41
Thank you I did figure out that it was a DNS issue and have since found my answered. I would close this post if I could figure out how.
  0  
  0  
#5
Options