Cloud send cmd failed for remote control activation lb100

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-01-05 08:44:24

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-01-05

Cloud send cmd failed for remote control activation lb100

2020-01-05 08:44:24

Model: LB100

Hardware Version: V1

Firmware Version: 1.8.11

Hi I am receiving an error when trying to turn remote control persmisions on. "Cloud send cmd failed"

please help

1 Reply

2020-01-08 08:19:39

Posts: 21892

Helpful: 5264

Solutions: 2604

Stories: 21

Registered: 2018-12-24

Re:Cloud send cmd failed for remote control activation lb100

2020-01-08 08:19:39

Hello, please ensure that the LB100 has connected to the main router's wifi, so does your cellphone.

Then try to reboot the LB100 and the main router to give it a go.

Besides, you can hard reset the LB100 and reconfigure it.

Still the same, please tell me the mac address of the smart bulb( or your cloud account).

Note: You can message us privately.

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE550 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, ECO Mode, and More Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.