I need to configure my Wi-Fi network so that the different APs have the same name so that when moving the signal never cuts out or I have speed problems. Currently the APs are connected by cable to a

It would be nice if the UI for the downlink port edits on the AP worked like the UI for the switch ports so you can just assign a profile and not specific VLAN settings. The EAP 615 UI is better, but

hi tplink, i'm having trouble with how the map shows the location of my switches. if you refer to the image image below, before this is the setup. however i since change the sx3008f to be the main, in

Hi, Network hardware: 1.28PORT switch- SG2428P v5.20 2.Router- ER605 v2.0 3. Hardware Controller - OC200 4. AP - 3X EAP235-Wall(US) v1.0 5. AP - 2X EAP265 HD(EU) v1.0 VLANs: 1. VLAN_1 - 192.168.0.x is

Hi everyone, I'm running below (simplified) network: I'm trying to get "Device" to run on a VLAN called test. This is that VLAN: In order to do that, I set Port 2 on Switch B to use the "test" profile

I have an ER605 router and I'm trying to configure firewall rules to allow communication between specific IP groups within my LAN. I've created IP groups for different devices on my network, but I'm u