terziyskiLV7Online
Following: 0Followers: 39
Forums/ DSL Modem Routers
27 minutes ago
Re:Archer Vr600v V1 on Vx800v Problems
@JulieUF There's no need to have two routers in this case since that will cause a double NAT in your network. You can use your VR600v in AP mode instead and keep its devices connected by using the...
0HELPFULS
Forums/ DSL Modem Routers
49 minutes ago
Re:How to configure VR2100 or VR400 so that WAN/LAN4 acts as a Backup internet connection.
@MartinGrossmann You've misunderstood the backup feature, but I have to admit that on the screenshot you posted it's a ittle bit misleading. Actually the only backup connection for these DSL momdem...
0HELPFULS
Forums/ Wi-Fi Routers
13 hours ago
Re:Block internet access from specific device while keeping the device connected to the router
@EnricoR I have to reproduce the steps but in general, when configured time to be online is 0, a warning pops up and warns that the devices won't have internet access at all and you just have to...
0HELPFULS
Forums/ Wi-Fi Routers
14 hours ago
Re:Help me with the setup 2 AP
@Marc_21 Ideally they should be connected to the router separately to avoid any bottleneck, but you can connect them in series if there's no other option.
1HELPFULS
Forums/ Wi-Fi Routers
15 hours ago
Re:Help me with the setup 2 AP
@Marc_21 You can use a switch in the topology like: Router->Switch->AP1 | ->AP2 or use the topology you described. Wireless channels can be set to "Auto". You can set the AP1 and AP2 SSIDs the same...
1HELPFULS
Forums/ Wi-Fi Routers
Yesterday
Re:Block internet access from specific device while keeping the device connected to the router
@EnricoR This was possible with the Access Control for the Old Green UI - details. As you noted, the new GUI Access Control will simply allow/deny the device access to the router's network. I've...
0HELPFULS
123...