I had a pretty busy end of week so I did not report my progress. It seems it takes some time for the router to get back to a fully-operational state after a factory reset: I came back next morning to...

@Yannie I checked, and there was in fact a duplicate fixed IP. I removed both fixed IP's in the controller, then plugged back the minimal network: gateway, controller, computer (in the LAN port)....

Yesterday, the DHCP service on my Omada network stopped working. I have since read this forum thread, which explains that this is caused by a firmware bug. The problem is: I can't connect to the...

I found my solution: one has to enable the PoE passthrough in the wall AP's web administration portal. As for the direct connection to my Tripp-lite PoE injector, it seems I did not plug it right in...

I have both an EAP235-wall and an EAP225-outdoor AP's, and a proper 802.3af/at injector (Tripp-lite NPOE-30W-1G). The wall plate works with the tripp-lite injector, but not the outdoor AP. I tried...

That explains the problem. It would be pertinent to update the spec sheet to indicate the EAP225 injector's standard. It's not indicated on the injector itself either - which in retrospect is very...