Region : UnitedKingdom

Model : TL-SG1016DE

Hardware Version : V1

Firmware Version :

ISP :

Hi,

I recently purchased this switch in order to use the VLAN function to separate my home network. Previously I've just had a one network with a unmanaged switch so this is all a bit new to me. I'm struggling to configure and I think there's a basic concept I've not got the grips with that I be really grateful of some pointers.

Setup
- Sophos UTM 9 (Previously Astaro)
- I have one NIC setup with two VLANs, 10 & 20.
- I've run a single cable to Port 1 of the switch
- On the switch I've configured 802.1Q VLAN as:
--- VLAN1 (Default), Port 1-16
--- VLAN10, Port 1 tagged, Port 2-8 untagged
--- VLAN20, Port 1 tagged, Port 9-16 untagged
--- VLID 1 (Default) = ID 1
--- VLID 2-8 = ID 10
--- VLID 9-16 = ID 20

As I understand it I now need to configure a trunk so multiple VLAN's can pass through the cable in Port 1. I can't quite make sense of the Trunk Config screen and the docs which leads me to believe I'm not understanding the trunking concept.

I've setup, Trunk 1 as Ports 1 only.

When I connect devices to the switch they do pickup the correct IP address, i.e. Port 16 (VLAN 20) will pick up 192.168.20.1 and Port 2 (VLAN 10) will pick up 192.168.10.1. But the devices don't seem to be able to get out despite the UTM having rules to allow access on all ports.

I've got hub and was going to use wireshark to try (Not an expert!) and get an idea of what's going on but wanted to see if I've misunderstood a basic concept. Any help would be very much appreciated.

Thanks, Ian.