Region : UnitedKingdom

Model : TL-SG3424

Hardware Version : V1

Firmware Version : 1.10.3 Build 20130609 Rel.39550

ISP :

Hi All,

Apologies if this has been asked before.

I'm trying to configure this switch via CLI but for some reason I can't enter Enable mode.

I can SSH to the switch, if I type in:

>enable

I get the error "no password set"

But If I type

>enable password admin

I get "Error too many paramaters"

If I try >no enable password

I get "incomplete command"

Could someone please direct me to the right command to either get into enable mode or set the enable password. This switch is relatively new, has basic configuration via Web UI so far.

Thanks for any help

Regards