ER605 FAILOVER NOT ACTIVATING
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello
Router
TP Link ER605 v2
Firmware: 2.0.0 Build 20220106 Rel.56391
PRIMARY WAN: Fibre Cable
Connection Type: PPPoE
Secondary WAN: 4G
Connection Type: Static IP
When Primary WAN is connected:
Internet is connected.
All 3 LAN ports work perfectly:
a) to PC
b) to Laptop
c) to Wi-Fi router. Wi-Fi Router then connects to multiple "client" devices scattered around the house.
When Primary WAN is NOT connected:
Internet is offline.
Secondary WAN does not activate, even though Failover Function is Enabled & Secondary WAN is "Connected".
I'm sure there is a Setting that I need to change, but I'm out of ideas.
Thank you for your help.
Hi @DEAN1964
Thanks for posting in our business forum.
1. Refer to the guide on the pinned thread in the router section.
2. Failover would take effect in several seconds. It is not instantly(1-2 seconds or less) to switch over.
3. Your firmware is not up-to-date but a factory default firmware. Would recommend you to upgrade to the latest one before any test.
Hi @DEAN1964
Thanks for posting in our business forum.
1. Refer to the guide on the pinned thread in the router section.
2. Failover would take effect in several seconds. It is not instantly(1-2 seconds or less) to switch over.
3. Your firmware is not up-to-date but a factory default firmware. Would recommend you to upgrade to the latest one before any test.
Hi @DEAN1964
I was back from a trip. I was not able to reply timely. But it is great to know that it's resolved.
Every day you learn something new. 