Routers
TP-Link Business Routers including Omada and SafeStream VPN series are designed for small and medium-sized enterprises demanding a flexible and secure VPN network. Anything related to TP-Link's Omada Routers or SafeStream Routers, welcome to ask questions, join discussions and share your experience/ knowledge here.
Routers
Hello, I have an ER605 V2 connected to 3 CPE710 V1 WAN devices at a location. I want my ER605 to do first Online Detection with RX Rate detection (ie: >10.0Mbps) and Load Balancing. Sometimes due to w
Load BalancingBandwidth ControlNetwork ConnectivityWAN Setup
By
Izzet5K
0Helpful
15Views
Hi, I am using an ER605 as the main router on my home network in a multi-wan setup. -wan 1 is connected to a fiber internet modem -wan 2 is connected to a 5G modem wan failover in is place: only wan 1
WireGuardLoad Balancing
1Helpful
117Views
Firmware Update Request for Enhanced IPv6 Support with Multiple ISPs and Load Balancing on the ER605
Dear TP-Link Support Team, I am using the ER605 V2 router, managed through the Omada OC200, in a business environment with three ISPs, utilizing the load balancing feature. However, I am facing a sign
Load Balancing
By
FernandoFA
· Latest post 2 weeks ago
by Clive_A
0Helpful
89Views
I have 2 ISP each 400mbps. when I plug my secondary ISP and set the load balancing to 1:1 ratio, the router only uses one WAN port instead of distributing the bandwidth to both ports. the other port h
Load Balancing
0Helpful
133Views
Hi guys. We upgraded from de TL-R480T+ to the ER605 because Gigabit was needed. Actually I created 9 IP groups but when trying to set Control Rules for each IP group only 6 appear. Is this the maximum
Bandwidth ControlLoad Balancing
By
evillarreal
· Latest post 3 weeks ago
by evillarreal
2Helpful
109Views
Is there a way to block a VLAN or IP Group from one but not all WAN connections? I have a network with three WAN connections. One is metered, two are unmetered. I have roughly 500 users with about 700
VLAN & Multi-NetworksLoad BalancingGateway ACL
2Helpful
220Views
I have multiple wan links setup on the ER8411 and had only setup the load balancing weight dependent on the various link speeds (1G - Link A, 500MB - Link B). seemed to work fine until the B line fail
WAN SetupLoad BalancingNetwork Connectivity
0Helpful
208Views
Failover only works when you turn off one of the devices, but not when one of the internet goes down. Companies that provide internet come with a GPON and a router. When the fiber signal in GPON drops
Load Balancing
By
Paulo_Beeny
· Latest post 2024-09-29 02:06:22
by Clive_A
1Helpful
281Views
I would like to know if it is possible to configure the noip on the router so that when a provider goes down I can still continue accessing cameras and other services at all times. I have 2 different
DDNSLoad Balancing
1Helpful
141Views
ER605 as VPN client with link backup WAN/WAN2 I have 2 VPN tunnels (ER605 as client), Problem is that they are down when router switched on backup link.(primary WAN Offline) Is there any way to reconn
VPNWAN SetupLoad Balancing
2Helpful
301Views