ER605 Does not pass Internet from WAN1 Port
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dear Team, I have set up an new ER605 with its default IP address and have enabled Link Balancing but the Internet through WAN1 Port does not go to LAN, os if Internet is there in WAN port then ER605 works fine but once the internet is removed from WAN Port ( but available in WAN1 Port ) the ER605 does not pass the internet from WAN1 to LAN Port
I did a factory reset and did all the settings. I have just masked the last digits of the IP address
System Status shows both WAN and WAN/LAN1 active.
In Load Balancing - online detection shows only WAN and in Link Backup only WAN shows up and no WAN/LAN1
My Case is both WAN are from fiber broadband and want the Load to be hsred between both ISP's - both to be active always and if any one fails the other takes over and now only WAN works and if WAN fails WAN/LAN1 does not work.I will not be using USB Modem. Please advice
@Clive_A Thanks a lot for the quick response. It was not a browser issue. Looks like V2.2.2 has lot of issues including this one. I upgraded to V2.1.5 beta and did a factory reset and everything is working fine.
1.) I have 2 Fiber Broadband WAN's but no 3rd WAN and have made the setup like below because want to use the both WAN's simultaneously. Hope it is correct ?
2.) In Load Balancing should i check - Enable Application based Optimized routing ?
3.) Is there a way to make Load Balancing 1:1 for WAN & WAN/LAN1
Please advice. Thanks a lot
Hi @Clive_A
Thanks for your quick response. I did go through the links you have provided and sorry to say it was not clear to me, as my case is different. Sorry to disturb you again, can you please clarify the below points. Thanks for your help.
1.) I have 2 Fiber Broadband WAN's active always but no 3rd WAN and have made the setup like below because want to use the both WAN's simultaneously. Hope it is correct ? or i need not use Link Backup at all and just use Load Balacning only ?
2.) In Load Balancing should i check - Enable Application based Optimized routing ?
3.) Is there a way to make Load Balancing 1:1 for WAN & WAN/LAN1