Weird issues on EAP 610 Outdoor
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Im have send an email to local TP-Link support (Malaysia), however im also ask here for other opinion and support
My 1st site is using 5 units of EAP 225 Outdoor, 2 units of EAP 225 Indoor, 3 units of EAP 610 Indoor and 3 units of EAP 610 Outdoor. ER605 is new and not yet configured.
The problem is on 610 Outdoor.
Steps taken:
i. Already tried with firmware EAP610-Outdoor(US)_V1.2_1.1.3 Build 20230330 and latest 1.2.0 Build 20230509 Rel. 67330.
ii. Downgrade to EAP610-Outdoor(US)_V1.2_1.0.6 Build 20220415 with no success.
1. EAP 610 only function with cable LAN connected either via Poe switch or Poe Injector. When try to switch to mesh (with LAN cable disconnect), it just remain status “Disconnected”. How to make this EAP able to mesh with other EAP?. Surprisingly, EAP name AP_PPCLOG works fine with mesh via latest firmware.
2. EAP 610 with name AP_PPCLOG, is able to mesh with EAP 225 indoor, EAP 225 outdoor and EAP 610 indoor. Current configuration is mesh with name AP_LINE. EAP 610 cannot mesh with other EAP 610 same model. Does EAP 610 cannot mesh with same model?. Picture below AP_PPCLOG cant see AP_PRESS
3. EAP 610 with name AP_PRESS is wired connected. No issue occur. The plan is to mesh between EAP 610 from EAP AP_PRESS.
Hope my explanation helps.
Best Regards
Saiful
