SFP patch cable
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi All,
I have ordered 2 switches, TL-SG2210MP and TL-SG2218. They both have 2 SFP ports I would like to use to connect them. They will both be in the same rack, so is there a recommenced .5 - 1' patch cable I could use? Any other tips would be helpful since I have not used SFP before. My hope is by using SFP it will free up 1 Ethernet port on each switch. Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I do not recommend using RJ45 transceivers. Quite opposite. In my view, they should be used only when you need to connect SFP to RJ45. DAC cables are commonly used to link SFP/SFP+ switches that are close to each other. They perform almost as good as fiber at 1G or 10G in short runs, just a little bit higher latency, and they already include necessary connectors. I use one to connect my SFP+ switches, but they can be used with SFP slots, too. Fiber cables are typically used for longer runs or in really crowded network closets. You probably will have difficulties finding short fiber cables.
- Copy Link
- Report Inappropriate Content
@s_track short distance as in same rack.. always use a DAC cable, this is the most cost effective way, else use multi mode or single mode fiber depending on distance/cost/availability. Ethernet transceivers are almost always the last choice.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
For such a short run, I would use a DAC cable. It is typically good for up to 5m. I would use a fiber cable for longer runs. I would stay away from links involving RJ45 because of increased latency. The total cost is higher, too.
- Copy Link
- Report Inappropriate Content
So I am confused. What is the real purpose of an SFP port? If you are just going to use a SFP to RJ45 converter, why use the SFP port in the first place? Why do you suggest a dac cable over a "standard" SFP patch cable that uses fiber? Thanks
- Copy Link
- Report Inappropriate Content
I do not recommend using RJ45 transceivers. Quite opposite. In my view, they should be used only when you need to connect SFP to RJ45. DAC cables are commonly used to link SFP/SFP+ switches that are close to each other. They perform almost as good as fiber at 1G or 10G in short runs, just a little bit higher latency, and they already include necessary connectors. I use one to connect my SFP+ switches, but they can be used with SFP slots, too. Fiber cables are typically used for longer runs or in really crowded network closets. You probably will have difficulties finding short fiber cables.
- Copy Link
- Report Inappropriate Content
@KJK Thank you, that was useful. I am having trouble finding a short SFP DAC cable. Most I find are SFP+. Can I use a SFP+ cable to connect 2 switches with SFP ports? Thanks again
- Copy Link
- Report Inappropriate Content
I have never tried it myself, but Internet says YES.
Search tip: "Can I Use SFP+ DAC Twinax Cable in SFP Ports?"
- Copy Link
- Report Inappropriate Content
@KJK Thank you!
- Copy Link
- Report Inappropriate Content
@s_track short distance as in same rack.. always use a DAC cable, this is the most cost effective way, else use multi mode or single mode fiber depending on distance/cost/availability. Ethernet transceivers are almost always the last choice.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 771
Replies: 8
Voters 0
No one has voted for it yet.