EAP225 Connected, Not Broadcasting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225 Connected, Not Broadcasting
Model :
Hardware Version :
Firmware Version :
ISP :
My EAP225 is showing as "connected" in EAP Controller software v2.4.7. It isn't throwing a signal at all.
I set this AP up yesterday in my office for a test-run before on-site deployment. Setup went ok, AP threw a strong signal that I could connect to with any wireless device I tried.
On the site this morning, I set it up exactly the same way I did yesterday-- It initially showed as "pending," as expected. I adopted it through the EAP Controller software, it provisioned, then connected. Showed a valid IP from the DHCP server. No signal on either radio. I rebooted the AP through the Controller software. Nothing. I deleted the AP from the Controller software and re-adopted it. Still no signal.
I rebooted the router to which it is connected. Had to go through the pending/provisioning/connected cycle again in the EAP Controller software (this surprised me a bit). It once again shows "connected" with a valid IP transmitted from the DHCP server, and I still have no signal coming from the AP.
What have I overlooked?
Hardware Version :
Firmware Version :
ISP :
My EAP225 is showing as "connected" in EAP Controller software v2.4.7. It isn't throwing a signal at all.
I set this AP up yesterday in my office for a test-run before on-site deployment. Setup went ok, AP threw a strong signal that I could connect to with any wireless device I tried.
On the site this morning, I set it up exactly the same way I did yesterday-- It initially showed as "pending," as expected. I adopted it through the EAP Controller software, it provisioned, then connected. Showed a valid IP from the DHCP server. No signal on either radio. I rebooted the AP through the Controller software. Nothing. I deleted the AP from the Controller software and re-adopted it. Still no signal.
I rebooted the router to which it is connected. Had to go through the pending/provisioning/connected cycle again in the EAP Controller software (this surprised me a bit). It once again shows "connected" with a valid IP transmitted from the DHCP server, and I still have no signal coming from the AP.
What have I overlooked?
