Bridge setup
I am setting up a Wifi bridge between 8 total buildings - Just want to know if this model or the EAP215 supports 1 master with 7 slaves. Since its wifi are they direct line of site?
3 buildings won't have LOS to the main building hence the WIFI bridge instead of a point to point system.
THe network will only be transmitting security camera's.
I can't find any literature about adding more slave or if they repeat similar to a mesh.
Only 4 Sub EAPs can be added at most:
And we can't build a string mesh network with EAP Bridge models like below.
EAP bridge1))) ((((EAP bridge 2))) (((EAP bridge 3
Only 4 Sub EAPs can be added at most:
And we can't build a string mesh network with EAP Bridge models like below.
EAP bridge1))) ((((EAP bridge 2))) (((EAP bridge 3
Thank you
Do they need LOS? or Could i do somethink like this - I normally just build ubuquiti PTP but the cost is going to be to much for the client, so trying an alternate solution
Buildings 4,5,6,7 Connected to Bridge 1 -- 13- 4k camera's
Buildings 1,2,3 Connected to Bridge 2 -- 13- 4k camera's
