Initial instillation, unable to connect with EAP655

Initial instillation, unable to connect with EAP655

Initial instillation, unable to connect with EAP655
Initial instillation, unable to connect with EAP655
Yesterday - last edited 15 hours ago
Model: EAP655-Wall  
Hardware Version:
Firmware Version: Latest

Can not connect to EAP655.  New home install with ER707-M2 router, TP-SG2824P switch, EAP655, and OC200 controller.  Can see my VLAN SSID but can not connect.  Accepts password but then never completes handshake.  If I use a different password it immediately rejects any connection so I think there is just some setting that needs to be changed.  Connected to the OC200 by ethernet cable.  Already did firmware updates on all devices.  Please be aware I am tech challenged.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Initial instillation, unable to connect with EAP655-Solution
15 hours ago - last edited 15 hours ago

Hi  @Sleem 

 

You mentioned you configure VLAN SSID, you may refer to the following guide, configure step by step:

How to configure Multi-Networks & Multi-SSIDs on Omada SDN Controller

 

If that's not your case, please let us know your requirements and share the screenshots of your configuration.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Initial instillation, unable to connect with EAP655-Solution
15 hours ago - last edited 15 hours ago

Hi  @Sleem 

 

You mentioned you configure VLAN SSID, you may refer to the following guide, configure step by step:

How to configure Multi-Networks & Multi-SSIDs on Omada SDN Controller

 

If that's not your case, please let us know your requirements and share the screenshots of your configuration.

Recommended Solution
  0  
  0  
#2
Options