krzysztofo wrote

Adopting EAP in mesh mode is impossible when management VLAN is used for the wired AP, it just fails. It would be great if this issue would get fixed or at least if the omada controller wouldn't allow it with some message.

 

I'm using oc200, but it's not probably connected to this.

Hi @krzysztofo 

Can you share how you configured the management VLAN? How many Omada devices you have and how did you deloy them?

For the management VLAN, please inform how you made the test, and some screeshots of your management VLAN page.

Hi  @VC-14 

This issue happens because 2nd EAP still wants untag network from main EAP. By default, when you click Adopt button, the 2nd EAP does not have management VLAN enabled. 

Try adopt both of the EAPs before enabling any managemnt VLAN. 

BTW if your management VLAN 3 is Network 1, the router's default VLAN, then I don't think you need to enable "management VLAN" on the EAPs. You just need to set up Access Control to limit other networks from accessing you VLAN 3. 

Only if you want to put the EAPs to another new VLAN network, you will need to enable "management VLAN", so the EAP itelf will use VLAN tagged data to communicate with the switch.