Switches
TP-Link Business Switches are comprised of JetStream series and LiteWave series, which are designed to offer reliable and professional choices to businesses of all sizes. Anything related to TP-Link's JetStream or LiteWave Switches, welcome to ask questions, join discussions and share your experience/ knowledge here.
Switches
Hello, currently my computer has two ethernet ports and one is connected to the internet and the other is connected to a local network where my machines are. No I would like to add more computers whic
VLAN & Multi-NetworksNetwork Connectivity
2Helpful
85Views
Hello, I'm struggling for weeks to setup VLAN with my SG2218P TP Link Switch. I read a lot of stuff and have been able to setup VLAN with another Netgear switch without issue and with a similar setup
VLAN & Multi-NetworksConfigurationNetwork Connectivity
2Helpful
109Views
Good mornign I have a TL-SG3452P Switch and I want to replace Cisco old device. I have a OMADA Controller with several AP already configured in my laptop on VLAN 1. Also, I use a Fortigate 60 F as Rou
VLAN & Multi-NetworksController RelatedNetwork ConnectivityConfiguration
By
Ericson574
· Latest post a week ago
by Clive_A
1Helpful
99Views
I have some of these switches in my network and some of them I can ping and they show up on an IP Scanner and they work properly but they show as offline on the controller and I cant connect to them v
Network ConnectivityController Related
1Helpful
81Views
Hello dear community! I run 2x TL-SG2428P switches and encountered an issue which I can't resolve: It seems on both switches the password eem to have changes. I use a password manager and I am very or
Controller RelatedPoENetwork Connectivity
2Helpful
218Views
Hello, we updated our SG3452XP v2.20 from Firmware 2.20.1 to a newer Version. There are two available: 2.20.3 2.20.4 We tested both and had network Problems. The switch is managed by Omada Hardware co
Firmware UpdateVLAN & Multi-NetworksNetwork Connectivity
1Helpful
242Views
I was hoping I could have the physical connections like in the table below and apply some network segregation rules at the Omada Router and apply the main firewall traffic rules at the PfSense. When I
VLAN & Multi-NetworksConfigurationNetwork Connectivity
By
HuntyBadger
· Latest post 3 weeks ago
by Clive_A
2Helpful
161Views
Hi Newby here and not that technical. I was using my switch with my broadband fine (IP 192.168.1.254) but I have changed provider and the IP address of the new BB router is 192.168.0.1 the same as the
Network Connectivity
4Helpful
178Views
Hello - curious if any one else has seen this problem and any ideas how to resolve. The desired behavior: When the switch boots up, the switch should receive a reserved dhcp address from the dhcp serv
ConfigurationNetwork Connectivity
1Helpful
154Views
Hello, I have a frustrating issue with the management site. Basically, when I use the default profile to the 10GbE ports, there isn't any speed problem, it communicates between the two ports aruond 6
VLAN & Multi-NetworksNetwork Connectivity
1Helpful
257Views