Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > Upgraded to AX6000, but my PoE cameras won't connecct

< Wi-Fi Routers

Upgraded to AX6000, but my PoE cameras won't connecct

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Upgraded to AX6000, but my PoE cameras won't connecct

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Richinwalla

2021-02-11 21:55:01

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-02-11

Upgraded to AX6000, but my PoE cameras won't connecct

2021-02-11 21:55:01

Model: Archer AX6000

Hardware Version: V1

Firmware Version: 1.1.1 Build 20200714 rel 18254

I replaced my Apple Extreme router with the AX6000. All devices connected except cameras which I have on a PoE switch, and two on Power line adapters. I see that all my devices (over 30) are on the routers subnet 192.168.0.1, but I know at least two of the cameras are on 192.168.1.xxx. Should I change the router's IP? and if so how do I do that?

2 Reply

Tony

2021-02-12 19:10:52

Posts: 6306

Helpful: 1491

Solutions: 165

Stories: 41

Registered: 2018-11-06

Re:Upgraded to AX6000, but my PoE cameras won't connecct

2021-02-12 19:10:52

@Richinwalla

You can either change the IP of the router or change the IP of the cameras. I am not sure which would be easier with respect to your network.

As far as the router, log into it and go to Advanced > Network > LAN > Change the IP there to 192.168.1.1

What will happen is when the router reboots it will start giving out IP addresses that start with 192.168.1.x automatically.

I'm not sure if the router is connecting to another router, but if the WAN IP of the AX6000 is already something similar to 192.168.1.x then just change the IP on the cameras in that case to reflect 192.168.0.x

Richinwalla

LV1

2021-02-12 19:35:06 - last edited 2021-02-12 19:37:57

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-02-11

Re:Upgraded to AX6000, but my PoE cameras won't connecct

2021-02-12 19:35:06 - last edited 2021-02-12 19:37:57

@Tony Hi, I ended up changing the IP of the router. Much easier than trying to change 5 cameras. My Apple Extreme was giving out IP addresses in the 10.0.1.xx range so I changed AX6000 to the same. Thanks.

Upgraded to AX6000, but my PoE cameras won't connecct

Upgraded to AX6000, but my PoE cameras won't connecct

Information

Voters 0

Tags