Change Internet Provider = Lost comms with T-P Link Switches & Light Bulb
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I recently switched from Xfinity to Frontier FIOS. Since, I lost communication with my two TP-Link switches and a Tp-Link light bulb.
How can I correct this?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Did your router and network credentials change? If so you would need to reset the products and go through the configuration process again to get them linked to the new router/SSID credentials.
- Copy Link
- Report Inappropriate Content
Thanks for the reply.
I can't find my original packaging/instructions. Where can I find what I need to follow?
I also can't get the router any closer to the installed switches.
Do I have to uninstall the switches for this?
I also have a TP-Link light bulb ... same questions?
AndyM52
- Copy Link
- Report Inappropriate Content
For switches under the toggle swtich are two buttons, a reset and a reboot. Hold the reset for about 30 seconds. for the bulbs just turn them on and off from the lamp 5 times. you want about 1 second between phases. If succesful the bulb will flash like it did when you first set it up. After this just reconfigure the device by following the onscreen questions. You should not need to relocate or unistall any of the devices.
- Copy Link
- Report Inappropriate Content
Thank you very much! On it! 😁
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 554
Replies: 4
Voters 0
No one has voted for it yet.