@Tony Actually, that firmware does work on the UK V3 adapters, I can boot into it using plcboot and my original PIB (downloaded using plctool). The issue I have is that the TP-Link Utility not only...

@Tony I downloaded a newer firmware from this forum post, in it they explain that the firmware should work for any powerline adapter that uses the QCA7420 chip, such as the TL-PA4010. Is this not...

Does anyone have a softloader for flashing the NVM/PIB files via plc utils? I've tried so many ways to get the firmware updated on my (now bricked) adapters, the TP-Link Utility bricked them and I've...

@PowerlineFW Where can I find a softloader? I can't get my adapters to save the NVM/PIB to flash without it.

@2MEX2 Oh. When I used the TP-Link utility it updated for a while then failed, which also bricked my V3 adapters. My V1.2 adapters updated fine, and all 4 were upgraded using their PIBs downloaded...

@2MEX2 What exact commands did you use? Whenever I try to flash I get an error (no NVM softloader present in flash memory, 0x71). I can run the new firmware without flashing but the device is...