ethereum-dadLV1Online
Following: 0Followers: 0
Forums/ Deco
a week ago
Re:Gigabit Switch Crashes my Entire Network
@HelpFixDecoApp Thanks for the detailed reply! All of the nodes had been working just fine until I initially tried plugging the switch into the main node, then after ~90 seconds the lights would turn...
0HELPFULS
Forums/ Deco
a week ago
Re:Gigabit Switch Crashes my Entire Network
Jasson_Hong wrote @ethereum-dad I don't think this issue is fully resolved yet. Based on my past experience, things may work fine at first, but after about 24 hours, the switch crashes again. I...
0HELPFULS
Forums/ Deco
a week ago
Re:Gigabit Switch Crashes my Entire Network
ethereum-dad wrote I connect the new switch to the main Deco (which is connected to the modem via it's other port) and all three nodes would turn red. The switch had the same issue with every node...
0HELPFULS
Forums/ Deco
a week ago
Re:Gigabit Switch Crashes my Entire Network
I believe I've solved the issue, unfortunately I wasn't able to gain any insight into the cause of the problem. Decided to try one last time before I went and returned the switch and somehow the...
0HELPFULS
Forums/ Deco
a week ago
Re:Gigabit Switch Crashes my Entire Network
yves_b wrote @ethereum-dad Is your Deco mesh running in Router or in AP mode? If your modem acts as a router (DHCP, NAT), you could perhaps run your Deco in AP mode, and see if it helps. Do you mean...
0HELPFULS
Forums/ Deco
a week ago
Re:Gigabit Switch Crashes my Entire Network
Jasson_Hong wrote @ethereum-dad Some switches do not support Ethernet backhaul, and I have encountered this issue before. After switching to a different model, the problem was resolved. I contacted...
0HELPFULS
12