@Dan_A I got tired of various issues with my Deco setup, and switched to a Unifi mesh with a Unifi Cloud Gateway and 4 mesh-points. No issues at all with this setup. It just works as it is supposed...

@Corne_S I actually have wired backhaul, but I wanted to use a 6E client. At some point of time, I'm switching to Unifi access points. This is my first Deco experience - the XE5300 was purchased in...

@HelpFixDecoApp Nope. It is different devices. The only commonality is that they are 2.4 GHz devices. And I have already tried setting the 2.4 GHz network as the preferred network. I also tried...

@HelpFixDecoApp Ok - so I reset all 4. Then made the XE75 into the main/primary Deco in the mesh, and made the other three into wired mesh-points. Same topology as above - mesh points are connected...

@HelpFixDecoApp There are 4 Deco devices. All three of the XE5300 are V1 and were purchased as a pack from Costco. The sole XE75 is V2 and was purchased from Amazon. I should note that I have never...

I have a 4-node wired mesh consisting of three Deco XE5300 and one XE75. So the backhaul is wired using a gigabit network switch. Everything works, unless I enable the 6 GHz network under WiFi...