@Riley_S Thanks Riley. I have checked multiple times through the Deco app and it is showing that I am running the following: - Deco x3600 (3 nodes, all updated to current firmware) - Firmware...

@Riley_S Thanks for this information @Riley_S. Looking at the page I realized the my Deco version is v1.6, so wondering if that will play a part in the ability to get these upgrades. I know that this...

@Riley_S Thank you for this. I have looked and this is not something that is enabled/available for me, or at least it is not showing. I am running an x68/x3600 network (sorry had x65 above) with the...

So have you tried setting that "failing" unit up as the main unit? So disconnect the current, working, one and start the whole process over to see if the second one is faulty. Process that I am...

@Riley_S Question with regards to the selection of signal sourcing. I have a similar setup in my house, two levels with finished basement (effectively 3 levels) with house running north south and...

@R5Ryder Something to remember is that if your nodes are physically that close you may run into interference problems. Normal stuff, check to make sure that each node is connected to the main node,...