@Carl Thanks for posting that wiring diagram! I had been wondering if this would be useable in the case where line and load are present in box A and a 3 wire bundle goes from box A to box B. Based on...

@B.Will I was able to test this idea out by taking an old rocker style switch and was able to determine that the holes for the face plates line up to both the kasa and the Leviton. I also noticed...

@B.Will I suppose that's a possibility. I took a look at the old toggle switches and they have slightly wide slots which allow up down movement. The previous wall plate fit ok and this is probably...

@B.Will there is no up down play in either switch when the screws are loosened.

@B.Will thanks for the thought on the backing plate. I'm not sure that is the issue. Here is an image with the backing plate off. The dumb switch sits lower than the kasa smart switch. Also a picture...

Hello everyone I just installed an HS200 in a 2 gang box and replaced the switch next to with with a Leviton decora rocker. The issue I am having is that the Leviton switch sits lower than the kasa...