nforcedragon wrote How to return to factory FW~~~ http://forum.tp-link.com/showthread....you-bricked-it Error 404. - broken link.

Many thanks for the link...will definitely give it a shot, now that I’m practiced in unbricking TP-Link routers!

Model : Hardware Version : Firmware Version : ISP : As I am inexperienced in use of third-party firmware for routers as supplied by OpenWRT, DD-WRT, et al, does anyone know if firmware -beta or...

Shield101 wrote Good sharing ~ So it looks like when choose Access point mode, the IPv6 cannot pass to the V4? there are so many posts on this forum, tplink stuff may miss this post, suggest you guys...

Finally, success! Used the C7v2 as primary router (provisioned with IPv6 addresses, etc,), then set up the C7v4 as "AP" extender. Got around the seemingly intractable IPv6 issue w/ C7v4 by using the...

Went through complete setup, as instructed by User Manual and previous experience w/ the V2: Powered off the modem, connected modem to C4 WAN port, powered on modem until it had completed bootup,...