CPE 210 setup and DNS
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE 210 setup and DNS
Model :
Hardware Version :
Firmware Version :
ISP :
I have a wired router (R470) for my WAN connection. I have a CPE 210 plugged into it as AP. Then I have another 210 setup as a bridge and rebroadcasting it.
It works good at times but it dies and comes back, works for a page then doesn't work, then comes back. If I reset it it works for a day or two. The rest of the network runs fine.
I was wondering if I used my real DNS on the 210 being a bridge? The lan is 0.1, the bridge 4.1. Can I put in the wan DNS 208.79.x.x?
Or put in the gateway as my DNS or leave the DNS blank?
Or any ideas what might be causing my outages?
Thanks
Hardware Version :
Firmware Version :
ISP :
I have a wired router (R470) for my WAN connection. I have a CPE 210 plugged into it as AP. Then I have another 210 setup as a bridge and rebroadcasting it.
It works good at times but it dies and comes back, works for a page then doesn't work, then comes back. If I reset it it works for a day or two. The rest of the network runs fine.
I was wondering if I used my real DNS on the 210 being a bridge? The lan is 0.1, the bridge 4.1. Can I put in the wan DNS 208.79.x.x?
Or put in the gateway as my DNS or leave the DNS blank?
Or any ideas what might be causing my outages?
Thanks
