@Ryan 

Hello Ryan:

On the first question, I don't know - I just came home from work and the LED was red. On the second question yes and no - I do 3D printing. The day after the reboot, the connection went down then back uo several times over the course of 8 hours. The LED did not turn red, however. During that time, no firmware updates, no Internet outages, but LED aside, the symptoms were the same - no communication over the wired Ethernet connection, but I had communication over Wifi. I just tried to get into it to check the logs - it's not accepting my password.

Lance

  @Ryan Hello Ryan:

Many thanks for trying to help me - unfortunately, the Decos became too unstable and I had to take them out and replace them with something else. I had two (active) nodes, they were approximately 12 feet apart with almost no obstructions. They were configured in access point/range extender configuration. What I was trying to do was provide Wifi for the room that has the Deco connected to the wired router, then in another room, connect a desktop PC wired to the Deco there. When the problem would occur, I could use a Wifi device to ping another Wifi device with no problem, but could not ping the router or systems on the wired network. It had been working fine since I got them up until about a week ago.