Xe75 Pro suddenly stopped connecting to the internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Xe75 Pro suddenly stopped connecting to the internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Afish

2023-05-22 15:52:56

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-05-22

Xe75 Pro suddenly stopped connecting to the internet

2023-05-22 15:52:56

Model: Deco XE75 Pro

Hardware Version: V1

Firmware Version: Unknown, updated to most recent

So, this is a common enough problem but I haven't found a resolution to help me fix it yet.

My deco set up has been working great, but suddenly stopped connecting to the internet (solid red LED). The network is still visible, but I'm unable to navigate it. I can't troubleshoot via the deco app because it cannot recognize the network.

I've done the hard reset manually on the main deco and redone the entire network multiple times, but when I do, the intent works fine for about 20 - 40 minutes before dropping off and not working again.

When I first set it up, I plugged the deco system directly into the modem/router connection where I'm staying and have 2 satellites, which worked for about 4 months no problem.

Also I updated the firmware based on a few recommendations, but it didn't help.

Any insight here would be great. Thanks all.

2 Reply

Riley_S

2023-05-22 17:36:42

Posts: 3009

Helpful: 888

Solutions: 117

Stories: 39

Registered: 2022-04-18

Re:Xe75 Pro suddenly stopped connecting to the internet

2023-05-22 17:36:42

@Afish,

If you are connecting to a modem/router combo, it is most likely that the Bridge Mode is no longer enabled on the gateway or something in your wired configuration has changed, such as connecting a second wired device directly to the Gateway.

I would recommend, if you have no access to the gateway settings, to set up the Decos in AP mode, as this will allow your gateway to operate as the modem and router for your network.

I would also recommend plugging a computer directly into the Gateway to see if the behavior continues without the Deco in play.

Check out the Latest: Getting Started with EasyMesh and TP-Link New Tablet Mode for the Tapo App Comparing the Latest Tapo Doorbells