Archer A7, Access Point mode, custom beacon interval
After switching to access point mode, it looks like the advanced "system parameters" UI section is gone. That contained some knobs that seem applicable to access point mode as well as router mode, such as custom beacon interval. Would love to hear of some work-around to get this back, short of installing OpenWRT.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
So the enigneers got back to me and let me know only specific products on an SPF platform will support the system parameters in AP mode. They did say that a work around would be to set the features in Router mode and then switch to AP mode. The settings will be maintained.
- Copy Link
- Report Inappropriate Content
I checked with the QA team and that section should still be there, even in AP mode. If you can please let me know what Firmware you are using and a screenshot that the menu is gone. I will need them to test.
- Copy Link
- Report Inappropriate Content
@Carl thanks for looking into this!
Firmware Version:
1.1.4 Build 20211022 rel.58866(5553)
Hardware Version:
Archer A7 v5.0
Here it is running in AP mode, showing the System Tools menu from the left. When running in router mode, there's a "System Parameters" sub-menu (all of this only visible when on the Advanced tab at the top of the page; notably the Basic and Advanced tabs are missing here).
- Copy Link
- Report Inappropriate Content
So the enigneers got back to me and let me know only specific products on an SPF platform will support the system parameters in AP mode. They did say that a work around would be to set the features in Router mode and then switch to AP mode. The settings will be maintained.
- Copy Link
- Report Inappropriate Content
@Carl thanks again for following up. It's good to know that the settings will be maintained, as it's not easy to verify these particular ones.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1178
Replies: 4
Voters 0
No one has voted for it yet.